Air Duct Mold Removal in Houston, TX
Call (713) 949-1410
Air duct mold removal in Houston homes
Houston attics stay humid most of the year. That humidity drives this job. Growth almost always starts at the supply plenum. Then it creeps into the first few feet of trunk. On fiberglass duct board, the liner itself is food once dust settles on it. Sheet metal trunks in pre-1970 houses sweat at bare seams. Flex duct sags between trusses and holds condensate in the low spots.
Look before you call anyone. Pull a ceiling register and shine a light inward. Dark staining on duct board edges is different from loose gray dust. Check the return side too. Leaky returns pull attic dust and loose fiberglass straight into the blower.
Cleaning alone fails if the cause stays. Eroded duct board liner cannot be scrubbed clean and should be replaced. A fouled evaporator coil keeps feeding moisture downstream. Disconnected boots in the attic must be resealed, or the growth returns by next summer.
Work is done on site with contained source removal and HEPA capture. Heavily degraded sections come out rather than get treated. Pier-and-beam homes with post-flood history in low runs usually need replacement, not cleaning.
If the real problem is a sized-wrong return, we say so.
Same-day air duct mold removal available in Houston, TX.
Call (713) 949-1410What happens after you call us
- 1
Call and tell us how many returns and supply vents you have, and we give you a two-hour arrival window with the tech's name. No charge for the visit, and no pressure to book anything on the phone.
- 2
We pull the attic hatch, check for sheet metal trunks or flex runs, count the registers, and look at the blower and coil. Then you get one firm number before a single vent cover comes off.
- 3
We clean every run, change the filter, test airflow at the farthest register, and vacuum up whatever came down with the hatch. You pay the number we quoted in the driveway, not a dollar more.